Proudly Made in Texas, USA

The Fabricators best friend

Bending

Utilizing the geometric pattern you can make accurate and repeatable bends. Place the pins in the table at your target angle with the angle apex on center as shown. Place the part on the table with the bend area just off the table. Heat the area of the bend until soft and place the bend on the apex pin. Bend to the pin that represents your desired angle and let cool slightly to set the angle.

 

Tip: If your piece is thin, you may want to use a block across the fixed area to keep from bending, and for repeatability a magnet or horizontal clamp can act as a stop.

 

Bending